Baker in Virginia
Member
Good Morning ,
I have a machine that I plan on replacing some very old Servo Drives with PowerFlex 525's ( 25B-D2P3N104 ). I would like to have the drive get a start input signal , run just a few forwards and reverses and then give an output saying that it is done. I would like the new drives to mimic the servos that are
in the machine at the moment . It is a very simple application that does not need a servo. The PLC is a SLC 500 .
Thanks in advance. Have a great week.
I have a machine that I plan on replacing some very old Servo Drives with PowerFlex 525's ( 25B-D2P3N104 ). I would like to have the drive get a start input signal , run just a few forwards and reverses and then give an output saying that it is done. I would like the new drives to mimic the servos that are
in the machine at the moment . It is a very simple application that does not need a servo. The PLC is a SLC 500 .
Thanks in advance. Have a great week.