Does anyone know if the Powerflex 525 has a manual mode option like Powerflex 753s do? For the Powerflex 753 I am using a 20-750-ENETR module to communicate with my PLC and reading the Logic Status word bit 9 to tell if the drive is set to manual by the HIM or not. I cannot find a similar status or parameter in the powerflex 525 manual and I am wondering if I am not looking in the right spot. Does anyone know if a similar function exists with the 525 and what it would be called?
Powerflex 525 Does Manual Mode Exist?
- Thread starter Sym_Boots
- Start date
JeremyM
Lifetime Supporting Member
Have a look at parameter B012.
You can also use bits 8 (ENetSpeedCtrl) and 9 (ENetLogicCtrl) of the LogicStatus word. The only inference you can make from them is that drive control comes from *something* other than ENet, such as the drive's terminals or the keypad itself.
You can also use bits 8 (ENetSpeedCtrl) and 9 (ENetLogicCtrl) of the LogicStatus word. The only inference you can make from them is that drive control comes from *something* other than ENet, such as the drive's terminals or the keypad itself.
Similar Topics
Good Morning ,
I am working on a project with some PowerFlex 525 drives. I am using CompactLogix 1769-L18. I took notice that the tags that...
Hello,
I'm hoping someone can help me with understanding how to set/change these data types. We recently swapped from Invertek to AB drives...
All,
I have a PowerFlex 525 driving an agitator motor. The goal is to have the agitator start automatically after a power loss or a comm loss. I...
Hi to all. We need to change a bad powerFlex 525 to a new one. How do you save the configuration to install in the new one? Thank you all for...
Im trying to teach a couple of labs on VFDs at a community college. We have some motor control trainers with P525s and 3 phase motors from...