I have Powerflex 525 with EIP interface where to ready bit goes off for some reason and the drive dont run. Things I have checked
1 Parameter T105 is set to fault enable. So If I have a issue with safeties i should be getting a fault 059 but when i check there is no fault on the drive
Stop command is issued only if the drive is active so i dont have a issue of race condition.
The only way to start is reset the safeties and drive ready bit goes 1. It is strange .
1 Parameter T105 is set to fault enable. So If I have a issue with safeties i should be getting a fault 059 but when i check there is no fault on the drive
Stop command is issued only if the drive is active so i dont have a issue of race condition.
The only way to start is reset the safeties and drive ready bit goes 1. It is strange .