Jasondelane
Lifetime Supporting Member
I've set up a powerflex 700 with Digital Input 1 (set to Stop - CF), and wired a pushbutton to give the input to clear faults. I've verified that the input is being received by monitoring the digital inputs on the him. I tested it by cutting power to the drive just long enough to get an undervoltage fault, but when I push the button, the fault doesn't clear. I've also tried setting Digital Input 1 to Clear Faults, still no luck. All other inputs except #6 are set to "not used", since I'm using 6 as an Enable.
Is there something I'm missing? Using the stop button on the HIM clears the fault fine.
Is there something I'm missing? Using the stop button on the HIM clears the fault fine.