Beggar
Member
Hello.
First off, I'm a relative novice with ProTool but getting better all the time. That said, I'm trying to include a control that shows a Green-Yellow-Red band to indicate "OK-Caution-Yikes" and it appears that the only option is the XGauge control.
I've put the control in and set the ranges and it displays fine in my ProTool CS screens. However, on the HMI (TP 270), the color bands do not show up. The gauge does work (the needle tracks the input value) but the bands are not there.
Any suggestions?
First off, I'm a relative novice with ProTool but getting better all the time. That said, I'm trying to include a control that shows a Green-Yellow-Red band to indicate "OK-Caution-Yikes" and it appears that the only option is the XGauge control.
I've put the control in and set the ranges and it displays fine in my ProTool CS screens. However, on the HMI (TP 270), the color bands do not show up. The gauge does work (the needle tracks the input value) but the bands are not there.
Any suggestions?