Putting PLC 5 into Program mode

Hi Allen
I've given this a try, and as you've predicted, I could not set the S bits. They are only status bits, I went to the data table and seen them toggle on/off as I am switching prog/run/test mode.
George
 

Similar Topics

esp400
Outputting numerical values from a sensor to PLC via DH-485
Some background: We have two assembly machines in house that make a part that gets crimped by deforming the top of a cylinder. We use a LVDT...
2
Replies
20
Views
3,987
esp400
esp400
L
Why is Rockwell putting VFD's on PLC network?
Does anyone know why Rockwell has changed the way they do their ethernet configuration? For years we used 2 ENBT modules, one to connect to our...
2
Replies
21
Views
7,392
lunenburger
L
M
Putting PLC time and date value in database
Hello, I am using wago 750-880 controller for my project. I am using SysRtcGetTime function to retrieve the time and date value of the controller...
Replies
1
Views
1,857
gclshortt
gclshortt
B
Power Flex drive outputting wrong speed to user's plc
Power Flex drive outputting wrong speed to user's plc.... HIM is reading correct but 4-20 ouput is wrong.
Replies
1
Views
3,560
DickDV
D
M
1756-L55 Processor putting itself to Remote Test mode?
Hi all, Any experience of the above? Happened 3 times now in 1.5 months. Processor is about 10 years old, software major revision is 19...
Replies
9
Views
5,557
I_Automation
I_Automation
Back
Top Bottom