[email protected]
Member
Hello,
I've done a search on the forums and found out some information about the 634 timeout error that I'm getting on the Panelview.
Our Panelview talks to a Logix5555 controller and a "634 Read Timeout Node 2" error keeps popping up. (Node 2 is our controller)
I've done the following:
1. I've made sure all cable connections are good
2. I've checked all points on the Panelview to see if it's available on the controller and checked all the data types to make sure they match.
3. Increased NUT from 5ms to 10ms and increased Interscan Delay from 160ms to 640ms.
4. Checked to see if PanelView UMAX is greater than Panelview Node number (UMAX=10, Panelview Node=5)
Any other ideas?
Appreciate any comments.
I've done a search on the forums and found out some information about the 634 timeout error that I'm getting on the Panelview.
Our Panelview talks to a Logix5555 controller and a "634 Read Timeout Node 2" error keeps popping up. (Node 2 is our controller)
I've done the following:
1. I've made sure all cable connections are good
2. I've checked all points on the Panelview to see if it's available on the controller and checked all the data types to make sure they match.
3. Increased NUT from 5ms to 10ms and increased Interscan Delay from 160ms to 640ms.
4. Checked to see if PanelView UMAX is greater than Panelview Node number (UMAX=10, Panelview Node=5)
Any other ideas?
Appreciate any comments.