PV550 Reset to factory default!?!

That is on the PV while not connected to anything. The PV configuration screen to be exact. But like I said before the program in that PV is not mine and I do not need to keep it. I figure it`s probably looking for the old PLC through the 1747-KE card. The thing is I hard resetted the PLC without uploading from it. I tried getting through it with the 1747-KE card but to no avail.

I know a possible solution would be to have another PV and a memory card to force my program into it but I don`t have access to that.
 
Ok, my problem was an age old newbie problem T_T. I connected my SLC5/03 to my UIC device using a cross-over cable which in turned fried my UIC device. For 400$ why don`t have protections :(. Anyway thank for the answers.
 

Similar Topics

S
PV550 add a stop
Is there a way to add a stop to the attached program? I want to stop it after the first rinse so the operator would have to push a button for it...
Replies
10
Views
1,226
sposb
S
J
PV550 612 No Active Nodes Found
I'm trying to connect a PV550 (2711-T5A2L) to a 1761-NET-AIC using a 1747-C11 cable (w/RJ45 removed) and the Phoenix connector. Can someone tell...
Replies
8
Views
2,668
Ken Roach
Ken Roach
mad4x4
Replacing PV550
We have an old machine that has been mothballed since early 2018 and management are looking at more work for it in 2022. The system runs on an SLC...
Replies
12
Views
2,874
plvlce
P
R
Allen Bradley PV550
Trying to write a program for a PV550 (2711-T5A16L1, Ser. B, Rev. E, FRN 4.46) to test the touchscreen. I wrote a program with 16 pages and on...
Replies
2
Views
1,695
RAYBRITO
RAYBRITO
P
PV550 Upload Issue
Good Morning Folks. Win Xp, PRO, Version 2002, SP3 RSLinx Classic 2.54 Using the AB UIC-485 driver with the 1747-UIC and a 2711-NC13 connected...
Replies
1
Views
1,222
PLC Pie Guy
P
Back
Top Bottom