Our local Cognex distributor usually helps with lighting. They offer to come look at the application and then test with parts back at their facility. This back and forth helps to make sure the camera works. Less headaches for me as the end user.
Question About Vision System Lighting
- Thread starter TonysControls
- Start date
dwoodlock
Lifetime Supporting Member
Lighting and wavelengths and proper setup of a vision system is a pretty big topic. Whoever your vendor is, should be able to assist with this if they are any good at what they do.
I'm sure you can do some reading on the topic as well if you google enough as well.
In a previous job where I was doing a lot of vision stuff, I mostly utilized CCS Lighting and they have a ton of options.
I'm sure you can do some reading on the topic as well if you google enough as well.
In a previous job where I was doing a lot of vision stuff, I mostly utilized CCS Lighting and they have a ton of options.
Similar Topics
Quick questions guys, How do you install an "Add-on Profile" module from a vendor like Cognex when trying to integrate one of their vision Checker...
Good morning,
I've had an inverter fail with firmware revision 5.002, the only spare is Rev 7.001, when updating the project with the new...
Hello all,
I'm doing some offline programming changes and have run into a problem. There is an instruction that looks like this
[/ D303 K12...
I recently uploaded an aplication from a Panel View, created a new screen and now that I've downloaded it to the Panel View, all the texts have...
I have never had the pleasure of working with a "Thermistor" until now and have a question. The Thermistor is a 10KOhm 4-20mA 2-wire device and I...