Hi
It becoming messy with all this pic but it easy.
1.Go setting (1) chose inputs 0.3 as interrupt .(PLC in Program)
2.In PLC Setting go to option Trasfer to PLC.The setting will trasfer to the PLC.
3.Copy (2&3) to file It should be the last file before the end (4).
(2) set the interupt.
(3)(This is the interrupt file each time input 0.3 go on the program jump and inc d201.)
4.Download it to your PLC.
Turn the PLC power Off Then On Then Run Mode.
It is very important to turn the power off and on in that way the setting would take effect.
PM me your e-mail I will send you all the project.
Good Luck