stasis
Member
thanks for all the suggestions from the previous posts...it's a learning process for me!
as far as the logic goes, I need to say that I've been in the field of industrial electrical for quite some time, so the comments of what/how to tie in an E-stop are not needed. It's the commands/instructions WITHIN RS that I need help with...
I've built & designed lots of systems, just never programmed anything more complicated than a Pico. I've only used RS for troubleshooting. In fact, as stated before, this position was held by someone else...he decided to quit & it (the position) was forced on me. That said, here is a redo of the jam detection program, complete with comments. Feel free to rip this one up as well!
as far as the logic goes, I need to say that I've been in the field of industrial electrical for quite some time, so the comments of what/how to tie in an E-stop are not needed. It's the commands/instructions WITHIN RS that I need help with...
I've built & designed lots of systems, just never programmed anything more complicated than a Pico. I've only used RS for troubleshooting. In fact, as stated before, this position was held by someone else...he decided to quit & it (the position) was forced on me. That said, here is a redo of the jam detection program, complete with comments. Feel free to rip this one up as well!