toddp65
Member
This counter is counting when bits_from_traypacker is true (messaging from other machine, this is the servo cycle). After counting 3 it should reset and the DN go true and drop out the sequence. It goes to 2 and then back to one. The backup eye bit that starts the whole sequence remains false. The purpose of this is to eventually stop and start a drive to lower the back pressure of 6 packs while being indexed into the packer (the servo is the push for the indexer). I only need it to do it for 3 cycles or the servo (thus the counter). I initially used Latch and Unlatch and it did the same thing but would eventual count up to the setpoint and go DN.
Thoughts?
Thoughts?
Last edited: