Hi all
Yesterday we had a failure with a powerflex 70 drive and had swap it with a similar replacement.
The powerflex drive had a 20-comm-d module installed which I've swapped over to the new drive.
However on testing, I'm unable to get the drive to communicate with the PLC over devicenet so unable run it in auto (displaying stopped) so aware just means waiting for the run signal.
Using Rsnetworx it has picked the newly fitted drive up and showing a electronic key mismatch (attached picture) on the product code.
To change this requires me to do a download with the processor in program which at the moment is not viable. Any other ways round this? Or just grit our teeth together and just go for it?
Also getting an error on the node itself for the drive in the diagnostic section giving error 00075 (Port 5 Adapter). Not sure what this is all about?
Any help much appreciated guys! Thanks
Yesterday we had a failure with a powerflex 70 drive and had swap it with a similar replacement.
The powerflex drive had a 20-comm-d module installed which I've swapped over to the new drive.
However on testing, I'm unable to get the drive to communicate with the PLC over devicenet so unable run it in auto (displaying stopped) so aware just means waiting for the run signal.
Using Rsnetworx it has picked the newly fitted drive up and showing a electronic key mismatch (attached picture) on the product code.
To change this requires me to do a download with the processor in program which at the moment is not viable. Any other ways round this? Or just grit our teeth together and just go for it?
Also getting an error on the node itself for the drive in the diagnostic section giving error 00075 (Port 5 Adapter). Not sure what this is all about?
Any help much appreciated guys! Thanks