hello i am a newbie to s5 and i have the following problem in a plant here.
the s5 crashed at general power failure
when the power came back on the auto mode does't work on manual mode several functions like lifting up or down a ramp don't work anymore
the software doesnt supply any alarm known
plc goes in run mode , i will look at the other leds and post their status here.
what do i need to debug this plc ? (cables , software ... etc)
cpu is 942
the s5 crashed at general power failure
when the power came back on the auto mode does't work on manual mode several functions like lifting up or down a ramp don't work anymore
the software doesnt supply any alarm known
plc goes in run mode , i will look at the other leds and post their status here.
what do i need to debug this plc ? (cables , software ... etc)
cpu is 942