Hello
I have a siemens 1500 connected to a redlion DA30
I use the redlion to write an operator entered number (retained) to a register in the PLC
operator entry
tag
when I start the machine up the redlion has a value, but the PLC does not .. any ideas
redlion on start up
plc on start up
After a start up, IF I enter a new value in the redlion, the PLC updates and shows the value.
my first thought is on start up of the redlion to (+1) to the register wait for a few seconds and then (-1) from it,
Has this happened to anyone else?
Thanks
I have a siemens 1500 connected to a redlion DA30
I use the redlion to write an operator entered number (retained) to a register in the PLC
operator entry
tag
when I start the machine up the redlion has a value, but the PLC does not .. any ideas
redlion on start up
plc on start up
After a start up, IF I enter a new value in the redlion, the PLC updates and shows the value.
my first thought is on start up of the redlion to (+1) to the register wait for a few seconds and then (-1) from it,
Has this happened to anyone else?
Thanks
Last edited: