DLMUK
Member
Hi,
Has anybody setup a system as follows before, Siemens are telling me it should be fine. But I cannot get comms.
S7-314C 2PN/DP - Configured as i-Slave address 111
Transfer areas 100 - 194 in use.
Profibus connector is in slot 2
3rd party device - has GSD file of S7-314 loaded in
it appears to connect to the S7-314 as address 111
shows 28 available slots
third party software vendor is mapping their system to slots 1, 2, 3, 4 etc
All values appear on vendor display as zeros even though they aren't.
On my TIA Portal "Network" view there is no DP Master configured, it is left as an "unassigned" connection. Siemens have confirmed this should be fine.
Has anybody managed to get comms before in this way without a master configured in TIA portal?
Thanks,
Has anybody setup a system as follows before, Siemens are telling me it should be fine. But I cannot get comms.
S7-314C 2PN/DP - Configured as i-Slave address 111
Transfer areas 100 - 194 in use.
Profibus connector is in slot 2
3rd party device - has GSD file of S7-314 loaded in
it appears to connect to the S7-314 as address 111
shows 28 available slots
third party software vendor is mapping their system to slots 1, 2, 3, 4 etc
All values appear on vendor display as zeros even though they aren't.
On my TIA Portal "Network" view there is no DP Master configured, it is left as an "unassigned" connection. Siemens have confirmed this should be fine.
Has anybody managed to get comms before in this way without a master configured in TIA portal?
Thanks,