Theres probably a simple solution to this but cant seem to figure it out.
I am making an addition to an existing piece of S7 software for a 315-2DP PLC, the software is already making use of the FC6 - AG SEND command. I wish to use the FC6 - DT to Date but it wont allow me to call it as its already being used elsewhere as FC6. I cant rename the FC as its a Siemens Block....
Any Ideas??
I am making an addition to an existing piece of S7 software for a 315-2DP PLC, the software is already making use of the FC6 - AG SEND command. I wish to use the FC6 - DT to Date but it wont allow me to call it as its already being used elsewhere as FC6. I cant rename the FC as its a Siemens Block....
Any Ideas??