Schneider LMC20 Loses Program

raccjim

Member
R
Join Date
Sep 2012
Location
Reading, PA
Posts
94
I have a machine which uses a Schneider LMC 20 Motion Controller connected to two drives. My problem is that any time the controller is powered down, the program is lost and must be re-downloaded via the MotionPro software.(annoying) Does anyone know if this is normal or is there a memory problem that I am unaware of? I have not found any indication of a battery in my documentation but the controller has been in service for about 8 years so if there is one I'm sure it needs changing...
Any help is appreciated!
 
Make sure that you "create boot project" when online with controller

If yes, then may be the time to upgrade to new one.
 

Similar Topics

R
Schneider Control Expert Multiple Monitors
Hi, Is Control Expert V15.0 supposed to support multiple monitors? I'm running Control Expert V15.0 on my host Windows 11 PC, connected to two...
Replies
1
Views
53
dalporto
dalporto
K
Schneider Modicon Premium TSX P57203Controller issue
Everything was working fine, but suddenly CPU went into error mode, and the ERR and TER LEDs lit up. Now I can't download or connect with the PLC...
Replies
0
Views
60
[email protected]
K
S
NTP for Schneider M580/M340
Hello all, I am wanting to update the system clock via NTP in the M580/M340. I'm aware that we are able to connect to a NTP in the controller...
Replies
4
Views
156
S.Woollett
S
M
Pack drive elau Schneider ISH-100
I am using Schneider elau pack drive servo motor ISH-100. I am facing the problem that On the ISH -100 red light is blinking and pack drive C-600...
Replies
0
Views
83
Munish
M
P
How to connect to Schneider M241 PLC remotely from EcoStruxure Machine Expert software using SSH tunnelling?
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
143
Para
P
Back
Top Bottom