Seeking Speaker recommendation

RadconFK

Member
Join Date
Aug 2014
Location
NY
Posts
4
Hi all - looking to add a speaker(s) to a Panelview +6 1000, using the USB port and existing audio driver. I am looking for something loud (10-20 watt range) and the speaker(s) will be installed in an operator interface enclosure in a wet environment - a clean room. The speaker can be mounted externally if able to be washed-down. 120vac/24vdc is available to power the speakers if required. Thanks :confused:
 
Seeking Speaker recommendation

I think that Hilliary Clinton is available for Factory Talks. I think though she is only a dry-speaker type, never agrees to a wash-down.
 

Similar Topics

Greetings All, I recently decided to start freelancing in Controls and Automation part time, most of my experience has been with Rockwell...
Replies
2
Views
155
I'd like to display 2 weights at an operator station on the plant floor. These two weights are in our L71 PLC as a DINT but I can easily convert...
Replies
4
Views
1,774
I have a PLC5/80E that I want to poll a Modbus device into using a Digi1. I have setup the message as a multihop going to the IP adress of the...
Replies
2
Views
1,437
As mentioned in the title, I want to learn about PLC systems. Long story short: I had to strip out a plant room. Everything was going to the...
Replies
9
Views
2,609
My attempt to communicate with Foundation Fieldbus transmitters with Pactware and a new, out-of-the-box Softing FF modem are a disaster - failure...
Replies
17
Views
5,046
Back
Top Bottom