Rsflipflop256
Lifetime Supporting Member
The project managers just found the OCI interface cable and are working on access to the siemens programming software, so I have some time to dink around.
A single timer will suffice for this im assuming, and put in the start range at its appropriate location in the instruction and should get the correct response from what i'm understanding, but I don't have access to the panel yet and its not fully hooked up.
Thanks again for the quick response!
A single timer will suffice for this im assuming, and put in the start range at its appropriate location in the instruction and should get the correct response from what i'm understanding, but I don't have access to the panel yet and its not fully hooked up.
Thanks again for the quick response!