Siemens 611U Tuning for Servo

dripdry

Member
D
Join Date
May 2016
Location
Ohio
Posts
23
Hey all. I'm stuck trying to tune a 611U, can't find anything in Scout for the life of me. Is there some automatic parameter setup area I'm missing? Some trick to it?

The servo is running but pretty badly (it's new).
 

Similar Topics

S
Siemens 611u drive fault A508 encoder fault
We havea 100kw AC motor with HEIDENHAIN encoders ERM 280speed encoder. The motor works ok up to 500 rpm under closed loop control. Anything...
Replies
1
Views
3,727
sammmy_s
S
J
Siemens PLC Help
HI everyone, i am new to Siemens plc programming and i am in need of some help. yesterday we had an S7-1200 CPU 1214C fail to turn on an output to...
Replies
4
Views
52
mk42
M
Itshouldwork
A way to detect online, hardware and software changes of Siemens TIA Portal V17
Hi PLC people, think about this scenario: The PLC is somehow connected to the same network with the facilities` network. Then someone connects to...
Replies
2
Views
33
mk42
M
M
ISSUES ASSIGNING PROFISAFE ADDRESS TO SIEMENS ET200ECO PN IO MODULE
Hello everyone, I've had this issue for the last 2 days where I try to assign the profisafe address to an IO block (6ES7 146-6FF00-0AB0) but when...
Replies
5
Views
139
baref00t25
B
P
SOFTWARE TIA PORTAL V14 - PLC SIEMENS
Hello, good morning, I have been having two problems with the Tia Portal software. The first is that I have installed it on my computer and...
Replies
5
Views
171
tdoa
T
Back
Top Bottom