Siemens Drive Question

arocon

Member
A
Join Date
Oct 2006
Location
Dubai
Posts
171
We use Sinamics S-120 for conveyor system. I am getting one roller table overspeed fault.
I am very new on drive. Could anyone tell me how to solve this.

Please tell me too how to calibrate or tune the motor. Or how to do the motor ID in drive ?Please provide me step by step procedure as i am very new in drive.

Thanks.
 

Similar Topics

M
Siemens Master Drive Question
We have three machines, and a LOT of Siemens Master Drives. Along with Siemens PLC's etc. etc. etc. Two of the drives were on one 'common...
Replies
0
Views
2,839
Mad_Poet
M
M
simodrive 611 from siemens question ??
i have a cnc lathe which used simodrive 611 from siemens , we have an orignal card came with the machine about more than 12 years which is...
Replies
0
Views
3,160
magdyfayad
M
A
Siemens CU_0_60 drive question
In Siemens CU_S_060 drive program Inputs/Outputs(Isolated Digiral inputs) are connected as follows X122 terminal 1 connected with green circle...
Replies
0
Views
2,319
arocon
A
P
Siemens Masterdrive Question
I am using a Siemens Masterdrive Vector control inverter drive. Control is by a S7-414 DP-2 through profibus. I want to jog the drive forward...
Replies
9
Views
6,827
JRW
JRW
K
Siemens S120 drive to control Lenze servomotor
Kindly, has anyone tried to control Lenze servomotors with Siemens S120 drives ? Any special hints ? Have some concerns for the resolver and servo...
Replies
5
Views
248
L D[AR2P#0.0]
L
Back
Top Bottom