tua32683
Member
Hi,
I am sure there is a very simple and logical explanation for this but I can't find it.
My system uses S-300 plc and there is a pointer used to turn on one of the outputs. When I monitor, I can see that output is turned on in the logic but output on ET200S I/O module is not coming. When I force the output it's turning on. Any ideas?
I am sure there is a very simple and logical explanation for this but I can't find it.
My system uses S-300 plc and there is a pointer used to turn on one of the outputs. When I monitor, I can see that output is turned on in the logic but output on ET200S I/O module is not coming. When I force the output it's turning on. Any ideas?