Siemens second HMI Step 7 5.5 + Portal V14

RMcNaughton

Member
R
Join Date
Nov 2017
Location
Dunfermline
Posts
2
I am wondering if anyone has set up a second siemens HMI using portal (V14) to a PLC programmed in step 7 5.5. I have attempted to do this using a proxy PLC in Portal V14 but I cannot get the HMI to communicate with the PLC. I have previously replaced an old HMI that was broken with a new one using a proxy PLC in portal and it worked fine but this was just a copy of the original. This time i want to add a totally new HMI to the system. Does anyone have any experience with this?
 

Similar Topics

R
Second Siemens HMI
I am wondering if anyone has set up a second siemens HMI using portal (V14) to a PLC programmed in step 7 5.5. I have attempted to do this using a...
Replies
5
Views
2,301
Lare
L
Lamboom
Creating a second LAN configuration for Siemens
Hi This is about making another wired LAN connection configuration. Ya know when you go to control panel/Network and Internet/network and Sharing...
2
Replies
25
Views
9,076
NetNathan
N
L
Siemens S7 224 Program Help Requested {SECOND REQUEST}
Hello everyone. On December 17th, I submitted a pdf (zipped) file of a program using Siemens S7-224. Has anyone taken on the task of looking at...
Replies
0
Views
6,766
ltrail
L
M
ISSUES ASSIGNING PROFISAFE ADDRESS TO SIEMENS ET200ECO PN IO MODULE
Hello everyone, I've had this issue for the last 2 days where I try to assign the profisafe address to an IO block (6ES7 146-6FF00-0AB0) but when...
Replies
5
Views
94
baref00t25
B
P
SOFTWARE TIA PORTAL V14 - PLC SIEMENS
Hello, good morning, I have been having two problems with the Tia Portal software. The first is that I have installed it on my computer and...
Replies
5
Views
141
tdoa
T
Back
Top Bottom