aczlan
Member
We have 3 SLC-150s that we are using, we would like to create a print for them and diagram the program so when we get approval we can replace them with something newer and so if something goes wrong we know where to look.
I was able to connect to all the PLCs and read the program, then save it as a .100 file, but I would like to open it in something a little easier to read than the DOS software.
I see some threads talking about converting the files to .txt or PDF, is there software available to do that?
Thanks
Aaron Z
I was able to connect to all the PLCs and read the program, then save it as a .100 file, but I would like to open it in something a little easier to read than the DOS software.
I see some threads talking about converting the files to .txt or PDF, is there software available to do that?
Thanks
Aaron Z