TigerCR1200
Lifetime Supporting Member
I have a SLC 5/04 that I need to change the scaling on two Analog points. This makes getting the 1784-U2DHP cable cost prohibitive. Chan. 0 is set up on System with the following settings:
Driver: DF1 Half Duplex Master
Baud: 9600
Parity: None
Stop Bits: 1
Node Address: 1
Control Line: No Handshaking
Error Detection: CRC
Polling Mode: Msg, Allow Slaves to Initiate
Duplicate Packet Detect: Checked
ACK Timeout: 50
Message Retries: 1
Reply MSG. Timeout: 1
Pre Transmit Delay: 0
I can disconnect the DB-9 connection so that I can hook up with a null modem cable. However when I do this I keep getting timeouts with the auto configure on the RS-232 DF1 Devices. If I try DF1 Slave Driver nothing comes through using the settings I listed above.
Does anyone have any advice for getting connected to this that does not involve purchasing 2000 dollar cables for a job that should only take 30 min?
Driver: DF1 Half Duplex Master
Baud: 9600
Parity: None
Stop Bits: 1
Node Address: 1
Control Line: No Handshaking
Error Detection: CRC
Polling Mode: Msg, Allow Slaves to Initiate
Duplicate Packet Detect: Checked
ACK Timeout: 50
Message Retries: 1
Reply MSG. Timeout: 1
Pre Transmit Delay: 0
I can disconnect the DB-9 connection so that I can hook up with a null modem cable. However when I do this I keep getting timeouts with the auto configure on the RS-232 DF1 Devices. If I try DF1 Slave Driver nothing comes through using the settings I listed above.
Does anyone have any advice for getting connected to this that does not involve purchasing 2000 dollar cables for a job that should only take 30 min?