tylerinthetub
Member
Hello guys, I'm a relative noob at this, but I picked up an SLC5/02 and the UIC cable off eBay and I'm having problems getting it to talk. I have installed the drivers and RSLinx is seeing the 1747 cable, but not seeing the processor.
The green USB light is on, the red DH485 light is off, not flashing at all. Switch is set to RS485.
The CPU fault light on the processer is flashing red, which I thought meant there is no program loaded, and the low battery light is on, because there's no battery in it atm.
Im running 32 bit Windows XP virtual machine on Windows 7 on boot camp.
I reset the processor to factory but no change, any suggestions would be great, or did I get a lemon processor?
Edit to add: RSLinx 2.54.00.11
The green USB light is on, the red DH485 light is off, not flashing at all. Switch is set to RS485.
The CPU fault light on the processer is flashing red, which I thought meant there is no program loaded, and the low battery light is on, because there's no battery in it atm.
Im running 32 bit Windows XP virtual machine on Windows 7 on boot camp.
I reset the processor to factory but no change, any suggestions would be great, or did I get a lemon processor?
Edit to add: RSLinx 2.54.00.11