snehavikas14
Member
I have to make a slide gate solenoid logic.
below are the requirements and circuit
This example drawing has an E-Loop switch. The tubes with this E-Loop are 9 thru 11 and 13 thru 16.
The gate hand switches are indicated as SW3 in the schematic. Subcontrator to remove the existing wiring of SW3 and replace it with NO contacts from the new relays that are located within the I/O panels. SW3 will then be wired as discrete inputs into the respective I/O panels, please refer to the Panel drawings attached for specific tube/IO panel correlation. For tubes with E-Loops, there will be a separate E-Loop switch that will follow the same suit. The E-Loop switch shall be removed from the existing circuit and replaced by new relays located in the I/O panels. The switch shall then be wired to the I/O panels as digital inputs. The relays for both SW3 and E-Loops are controlled by the PLC, which is triggered from the inputs from the switch inputs
below are the requirements and circuit
This example drawing has an E-Loop switch. The tubes with this E-Loop are 9 thru 11 and 13 thru 16.
The gate hand switches are indicated as SW3 in the schematic. Subcontrator to remove the existing wiring of SW3 and replace it with NO contacts from the new relays that are located within the I/O panels. SW3 will then be wired as discrete inputs into the respective I/O panels, please refer to the Panel drawings attached for specific tube/IO panel correlation. For tubes with E-Loops, there will be a separate E-Loop switch that will follow the same suit. The E-Loop switch shall be removed from the existing circuit and replaced by new relays located in the I/O panels. The switch shall then be wired to the I/O panels as digital inputs. The relays for both SW3 and E-Loops are controlled by the PLC, which is triggered from the inputs from the switch inputs