Hi,
I am currently developing a HMI to replace an old screen that is no longer available to purchase. The plan is to connect the panel view to the square D processor (4224) via it's 422 port.
I was going to use the NR&D SC902 232-422 converter and then use kepware to manage the translation.
Does anyone have any experience with this? I have seen it done before using a SPE04 card but in this case I wanted to go direct to the processor.
Any advice? I will be doing this in 2 days time and any info before I get dropped in it would be much appreciated.
I am not sure of anything at this stage.
Do I have the right adapter?
what is the pin out?
What driver should I use in kepware?
I will attempt to answer this myself however if someone has done this before it will save me a lot of time.
Thanks.
I am currently developing a HMI to replace an old screen that is no longer available to purchase. The plan is to connect the panel view to the square D processor (4224) via it's 422 port.
I was going to use the NR&D SC902 232-422 converter and then use kepware to manage the translation.
Does anyone have any experience with this? I have seen it done before using a SPE04 card but in this case I wanted to go direct to the processor.
Any advice? I will be doing this in 2 days time and any info before I get dropped in it would be much appreciated.
I am not sure of anything at this stage.
Do I have the right adapter?
what is the pin out?
What driver should I use in kepware?
I will attempt to answer this myself however if someone has done this before it will save me a lot of time.
Thanks.