Hi All,
I am looking for some help on a little project that I have inherited (Landed in my lap)
We have a 5-position index table that each part needs to be soaked in one position and index to the next part until complete,
we are trying to use a D0-05DL PLC from Automation Direct controlling a STP-DRV-6575 the motor used is a STP-MTR-23055. also, not sure if this will need an Encoder
Just looking for advice on the best and easiest option to control this if anybody would have a similar project as an example, I would be very grateful.
P.S. this is my first time using the DirectSOFT6 software
Thank you
Noob
I am looking for some help on a little project that I have inherited (Landed in my lap)
We have a 5-position index table that each part needs to be soaked in one position and index to the next part until complete,
we are trying to use a D0-05DL PLC from Automation Direct controlling a STP-DRV-6575 the motor used is a STP-MTR-23055. also, not sure if this will need an Encoder
Just looking for advice on the best and easiest option to control this if anybody would have a similar project as an example, I would be very grateful.
P.S. this is my first time using the DirectSOFT6 software
Thank you
Noob
