Hi All,
Have a question about setting up routing across VLANS.
I have attached a picture of the layout and will try describe best I can.
https://ibb.co/s6vFskv
Would like to have VLAN30 be able to access VLAN10 and VLAN20. BUT VLAN 10 & 20 not have any access to each other.
This is the guide I was following:
The only difference is that I am also having a connection to another switch via a Trunk line.
Getting this error when trying to enable routing.(See Below)
https://ibb.co/Sf3XmQ4
VLAN settings on JM MS 02
https://ibb.co/tHyswBx
In SDM-Template I have selected "Lanbase routing"
I have both switches setup with the same VLAN settings.
Is there anything I am missing here?
Have a question about setting up routing across VLANS.
I have attached a picture of the layout and will try describe best I can.
https://ibb.co/s6vFskv
Would like to have VLAN30 be able to access VLAN10 and VLAN20. BUT VLAN 10 & 20 not have any access to each other.
This is the guide I was following:
The only difference is that I am also having a connection to another switch via a Trunk line.
Getting this error when trying to enable routing.(See Below)
https://ibb.co/Sf3XmQ4
VLAN settings on JM MS 02
https://ibb.co/tHyswBx
In SDM-Template I have selected "Lanbase routing"
I have both switches setup with the same VLAN settings.
Is there anything I am missing here?