ScottTheEngineer
Member
OK, Looking for a bit of assistance here. I have Studio 5000 Logix Designer software V24 running on my PC and laptop.
In my MAIN PLC program I have 3 Powermonitor 5000 units. All say <EDS UNREGISTERED> with a name and a question mark. If if hold the mouse over the tag I can see the IP address which is correct.
I can and have uploaded the EDS sheet from the device and created it In Administrator mode but It still doesn't work.
Ok, so software problem with studio 5K? no problem reinstall?
But,
If I open a different Studio5000 PLC program on the PC I see the 3 Powermonitor 5000's and can go online with them.
On my Laptop I have the exact same software except, I have 3 powermonitor 5000's that I can go online and read data fault state etc... using both PLC programs.
I tried going offline with the PC, deleting the Bad powermoniters then uploading as well as Trying to register offline.
The thing that gets me is it only doesn't work on one PLC program and only on 1 computer. Its just fine on the laptop.
The same file is running on both the laptop and the PC off the network drive.
Both Computers have same version of RSlinx.
Both the PC and Laptop have same .NETFramework version and windows updates.
.NET had my home computer so screwed up trying to get autocad electrical installed that I had to Format the C drive.
In my MAIN PLC program I have 3 Powermonitor 5000 units. All say <EDS UNREGISTERED> with a name and a question mark. If if hold the mouse over the tag I can see the IP address which is correct.
I can and have uploaded the EDS sheet from the device and created it In Administrator mode but It still doesn't work.
Ok, so software problem with studio 5K? no problem reinstall?
But,
If I open a different Studio5000 PLC program on the PC I see the 3 Powermonitor 5000's and can go online with them.
On my Laptop I have the exact same software except, I have 3 powermonitor 5000's that I can go online and read data fault state etc... using both PLC programs.
I tried going offline with the PC, deleting the Bad powermoniters then uploading as well as Trying to register offline.
The thing that gets me is it only doesn't work on one PLC program and only on 1 computer. Its just fine on the laptop.
The same file is running on both the laptop and the PC off the network drive.
Both Computers have same version of RSlinx.
Both the PC and Laptop have same .NETFramework version and windows updates.
.NET had my home computer so screwed up trying to get autocad electrical installed that I had to Format the C drive.