Dear sir,
i have used wincc for scada. in that press left click event write script of settagbit and on release left click event write resettagbit. it is working ok if use only left click.
Now,if i press the push button using below mention sequence
1) left click
2)without release left click press right click
3) release right click
4) release left click
then the tag bit contionue set to 1. after contionue operation if again press left click and release reset the tag bit.
this operation create trouble when start the conveyor working ok only through single left click. but operator start this using above condition conveyor contionue run. if there is some interlock then it stop but again start if that interlock clear.
so suggest me way to clear this issue without add extra script. one way i know is write resettagbit script of release left click copy to press right and release right event.
wait for your positive response.thanks and regads,
kalpesh makvana
i have used wincc for scada. in that press left click event write script of settagbit and on release left click event write resettagbit. it is working ok if use only left click.
Now,if i press the push button using below mention sequence
1) left click
2)without release left click press right click
3) release right click
4) release left click
then the tag bit contionue set to 1. after contionue operation if again press left click and release reset the tag bit.
this operation create trouble when start the conveyor working ok only through single left click. but operator start this using above condition conveyor contionue run. if there is some interlock then it stop but again start if that interlock clear.
so suggest me way to clear this issue without add extra script. one way i know is write resettagbit script of release left click copy to press right and release right event.
wait for your positive response.thanks and regads,
kalpesh makvana