The Siemens MP277 and Omron Sysmac CJ1M

[Japaunks]

I've programmed both the MP277 and CJ1M CPU12, but I can't make them to communicate. I've tried configuring their addresses and nodes, Baud rate, parity and etc and none of them works?

Any idea how to make them communicate? I've use the cable that comes with TD200.

Is there any special cable for them to communicate?

Thanks!

 

[PeterMalt]

You have read this form siemens http://support.automation.siemens.c...lib.csinfo&lang=en&objid=18797249&caller=view ??

Chapter 7.1

The connection of an HMI device to an OMRON CPU of the OMRON SYSMAC C (not CQMCPU11/
21), SYSMAC CV, SYSMAC CS1, and SYSMAC alpha series using the
Hostlink/Multilink protocol over RS232 has been system tested and released by Siemens AG.​