ziyaddin2015
Lifetime Supporting Member
Hi All,
We have encountered a problem with one of two servos that feed paper. The infeed roll was replaced and diameter of a new one is slightly bigger. Its pulling a bit hard and dropping dancing bar all the way down to the bottom sensor which then errors out if not cleared in four cycles? I dont want to change outfeed roll because its still in good shape but I was wondering if there anything else can be done logicwise?? Thank you
Sero motors MPL-B220T-Exx
Powerflex 40
Rslogix5000
We have encountered a problem with one of two servos that feed paper. The infeed roll was replaced and diameter of a new one is slightly bigger. Its pulling a bit hard and dropping dancing bar all the way down to the bottom sensor which then errors out if not cleared in four cycles? I dont want to change outfeed roll because its still in good shape but I was wondering if there anything else can be done logicwise?? Thank you
Sero motors MPL-B220T-Exx
Powerflex 40
Rslogix5000