TurnerT2005
Member
Is there a way to know internal addresses of inputs and outputs by looking at the WAGO module wiring and lights?
Wago 750-343
- Thread starter TurnerT2005
- Start date
http://www.ormec.com/LinkClick.aspx?fileticket=Ge0QSwmlwbM=&tabid=78&mid=448à
a quick google search bring me here
a quick google search bring me here
it is not simple but possible.
it depends on the type and number of inputs and outputs.
an analog input is one word
an digital input is one bit in a word.
see manual for a complete list and where to start.
it depends on the software you are using.
it depends on the type and number of inputs and outputs.
an analog input is one word
an digital input is one bit in a word.
see manual for a complete list and where to start.
it depends on the software you are using.
Similar Topics
Is there a way to know the internal addresses of the inputs and outputs of a Step 7 plc by looking at the wiring location or lights on the WAGO...
Hello,
I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
I have a project to setup base programs across multiple PLC platforms that can be used for Modbus communications to various sensors that have...
Hello,
I m having a problem with wago 750-862 plc.
The plc won't start automatically in run mode after a power reboot.
I've also tried the...
Hello everyone, I am trying to setup a Wago 750-8100 PLC to send a text message out via ethernet port, if I get a Digital input that is true. I...