weintek and Micrologix addressing Problem

sultanahmed

Member
S
Join Date
Jul 2013
Location
home
Posts
63
Hi Every one,

I have been using weintek HMI with multiple PLCs,
but it is quite confusing for me to define addresses for rockwell plc in easy builder pro that is connected with micrologix series via DF1.

if some one can advise thumb rule for allen bradly adressing.
for example
I1/0
I1/15
I2/0
O3/0
b3:2/0
n7:34/6

Pleaseo_O
 

Similar Topics

TimWilborne
Weintek to Micrologix PLC
I'm doing my first Weintek project using a Micrologix 1400 PLC and need some help with my communications configuration. I am using the "Rockwell...
Replies
6
Views
2,836
TimWilborne
TimWilborne
S
Weintek HMI and Micrologix 1200 communication
Dear all, Recently i found Weintek HMI and its software Easybuilder 8000. Now i want to communicate Weintek MT6050i HMI with Allen Bradley...
Replies
10
Views
8,251
Sakubh
S
BobB
Weintek touch screens - first impressions.
I require remote access to my projects that are away from home. I did some homework and decided that Weintek looked to have a good solution. Set...
Replies
4
Views
160
bill4807
B
S
FX2N PLC Integration with 2 Weintek HMI.
Hello everyone, I am currently facing a challenge while trying to connect two Weintek HMI units with a Mitsubishi FX2N PLC. When connecting a...
Replies
5
Views
556
Steve Bailey
Steve Bailey
F
Weintek MT8150XE font issue
I have been using two of these HMIs on two sites with similar projects but developed separately. Now i want to use screens from one on the other...
Replies
0
Views
360
finianm
F
Back
Top Bottom