Westinghouse series 700/900 instruction manual

mthib

Member
M
Join Date
Mar 2007
Location
Maine
Posts
1
Hi All,
I'm new to the site as a member but have viewed info here often. I'm converting an old Westinghouse HPPC1500 and most of the instructions I can figure out. There are some I'm not sure of.

Does anyone know where I can download (or purchase) a manual on the instruction set?

Can any explain how their "ONE SHOT" works as well as the "TIME OFF"

Thanks
 

Similar Topics

W
Teco Westinghouse A510 VFD comms
Hello: I am confused about the A510 modbus addressing scheme. According to Teco's communication addendum the modbuss register addresses start at...
Replies
4
Views
1,699
bigmuz
B
T
Numa logic Westinghouse PLC
I have problem whit communication on this device . When I check pc status in softwere i get error type "communication error". My cable for RS232...
Replies
3
Views
2,470
t0r3r0s
T
B
OT: Old Westinghouse Heaters
I have been looking for an Old Westinghouse Heater chart. I have a old DO-ALL saw which was running on 480v 3ph it was swithced over to 240 3ph...
Replies
7
Views
3,250
allscott
allscott
3
Westinghouse PC-110-101
I am in dire need of a programming manual for this really old PLC. We have a NLPL-180 programmer to use, but ATS and Eaton don't have any info...
Replies
0
Views
1,530
3edsaylor
3
P
Westinghouse PC1100/1200 manuals/software?
I know there's been several threads on this in the past, as I've searched the forum and read all of those already. Tried contacting Advanced Tech...
Replies
9
Views
7,512
alperkara
A
Back
Top Bottom