There is just a single laptop. I used it to program the plc "s7-200 cpu214" successfully. But when i tried to connect it with the wincc, there was no response.
Here is the detail
baud rate = 96200 bps
cable ppi
one memory tag M0.0
one input tag I0.0
two outputs Q0.0 and Q0.1
Program is simple
M0.0 energizes Q0.0
I0.0 energizes Q0.1
At the basic level I just want to see their response in wincc before going to complex screens.
All the tags have been correctly configured, they run fine in simulation and do their job, but when it goes to runtime operation, there is no response at all.
If you can help me through this, my whole project is struck at this point.