chrisref
Member
Hello guys.I'm new user in the site.I have a problem.
I have connected my xc3 plc to a device which is an electronic board with leds.In my programm I have an increase counter and I want to pass each value of the counter from plc to the device.I have found the instructions from the manuals and the parametres are correct.The problem is that when I check with a scopemeter if the value is passing to the device, the scopemeter shows me always the same.The same when the counter value is 1 or 56.Does anyone Knows if i forget something?Should I convert plc from slave to master? I am new user of the plc's so I would be very happy if anybody provided me some help with this situation.Thank you.
I have connected my xc3 plc to a device which is an electronic board with leds.In my programm I have an increase counter and I want to pass each value of the counter from plc to the device.I have found the instructions from the manuals and the parametres are correct.The problem is that when I check with a scopemeter if the value is passing to the device, the scopemeter shows me always the same.The same when the counter value is 1 or 56.Does anyone Knows if i forget something?Should I convert plc from slave to master? I am new user of the plc's so I would be very happy if anybody provided me some help with this situation.Thank you.