ferni4988
Lifetime Supporting Member
Hey everyone I am very new to the Omron world. I just got this new job and they have an old palletizer that is ran through an Omron CQM1H-CPU51. They've never had anyone on site that can look at the program and troubleshoot it and long story short they dont even have the program for the palletizer. i am trying to upload the program from the palletizer to get familiar with it and begin to troubleshoot some of the on going problems (ie, photo eyes not working correctly). Sorry for the long story but I am having problems connecting to the PLC.
I am using CX programmer v. 9. When I connect to the PLC and try to go online I get an error that says "Fail to Upload the Program" and I get fatail errors, one of which is "No END(1) instruction". Has anyone experienced this before or can anyone help my ignorance and guide me through uploading the programs. I dont know if it matters but when I connect to the PLC it reads it as a CQM1 PLC instead of a CQM1H, not sure if this matters. I am kind of lost here and any help would be very greatly appreciated.
Thanks
I am using CX programmer v. 9. When I connect to the PLC and try to go online I get an error that says "Fail to Upload the Program" and I get fatail errors, one of which is "No END(1) instruction". Has anyone experienced this before or can anyone help my ignorance and guide me through uploading the programs. I dont know if it matters but when I connect to the PLC it reads it as a CQM1 PLC instead of a CQM1H, not sure if this matters. I am kind of lost here and any help would be very greatly appreciated.
Thanks