Vintage L551 - series C - FRN 5. SDN is same vintage.
Replacing old 1336 with PF755, which so far hasn't been much of an issue on the programming side.
Easy to write all command bits to drive, read status bits, set speed in RPM and read speed in RPM.
Here are a couple of screenshots, and this all works.
Problem is, I need to be able to read motor current, and not sure how, or if possible to get it from the drive to PLC over Device Net.
Data links? Any ideas?
Thanks!!
Replacing old 1336 with PF755, which so far hasn't been much of an issue on the programming side.
Easy to write all command bits to drive, read status bits, set speed in RPM and read speed in RPM.
Here are a couple of screenshots, and this all works.
Problem is, I need to be able to read motor current, and not sure how, or if possible to get it from the drive to PLC over Device Net.
Data links? Any ideas?
Thanks!!
Last edited: