Hi,
I need advice about measurement of DC current up to 1000A and getting 4...20mA on PLC's input.
I can't use shunt, so I will need something like this:
http://www.nktechnologies.com/wp-content/uploads/protected/DT_Large_Datasheet_v1116.pdf
Is it fine to use it just like it is and to connect it directly on PLC's AI, or it is better to use it through barrier?
Thanks.
I need advice about measurement of DC current up to 1000A and getting 4...20mA on PLC's input.
I can't use shunt, so I will need something like this:
http://www.nktechnologies.com/wp-content/uploads/protected/DT_Large_Datasheet_v1116.pdf
Is it fine to use it just like it is and to connect it directly on PLC's AI, or it is better to use it through barrier?
Thanks.