Márcio Santos
Member
Good Morning.
I bought a microLogix 14000 plc and can not communicate with it in serial. I am using a USB / 232 adapter. I made all the configurations in Rslinx, check COM ports, cable drive and everything is correct. but when I try to do the AUTO-CONFIGURE it sends the following faults
1-failed to find the baud and parity
2- check all cable and switch setting.
I also noticed that the FAULT LED on the plc is lit steadily.
can help? thank you.
Remark: I am using the original cables, exeto usb /RS232
I bought a microLogix 14000 plc and can not communicate with it in serial. I am using a USB / 232 adapter. I made all the configurations in Rslinx, check COM ports, cable drive and everything is correct. but when I try to do the AUTO-CONFIGURE it sends the following faults
1-failed to find the baud and parity
2- check all cable and switch setting.
I also noticed that the FAULT LED on the plc is lit steadily.
can help? thank you.
Remark: I am using the original cables, exeto usb /RS232