Dear All
I have a Laser on my table where I communicate via Putty over Ethernet IP
I have setup the Putty with a RAW connection and an IP address.
I control the Laser via string commands and everything works great
Now I would like to move this over in a compactlogix PLC, all my string communication in the past have been true serial ports, so I have never setup a generic module to send out strings.
Is this even durable, I have search high and low, but haven't found the right solution.
Has anyone done this before ??
Regards
/Holmux
I have a Laser on my table where I communicate via Putty over Ethernet IP
I have setup the Putty with a RAW connection and an IP address.
I control the Laser via string commands and everything works great
Now I would like to move this over in a compactlogix PLC, all my string communication in the past have been true serial ports, so I have never setup a generic module to send out strings.
Is this even durable, I have search high and low, but haven't found the right solution.
Has anyone done this before ??
Regards
/Holmux