cartersrroom
Member
Connected Components Help
Hi there everyone,
I’m recently new to the PLC world and was hoping somebody might steer me in the right direction.
I’m currently writing a project on connected components V21 and need to do the following task:
A master system is sending me hard wired outputs telling me when certain motors must raise and lower. I then raise and lower these motors and tell the master system via hard wired outputs when the motors have reached their proximity limits.
I’ve written a step sequence for this but don’t think I’m on the right track and would love if someone could just point me as to what wording to use when researching a solution for this on google so I can continue my studies into it.
TIA appreciate it
Hi there everyone,
I’m recently new to the PLC world and was hoping somebody might steer me in the right direction.
I’m currently writing a project on connected components V21 and need to do the following task:
A master system is sending me hard wired outputs telling me when certain motors must raise and lower. I then raise and lower these motors and tell the master system via hard wired outputs when the motors have reached their proximity limits.
I’ve written a step sequence for this but don’t think I’m on the right track and would love if someone could just point me as to what wording to use when researching a solution for this on google so I can continue my studies into it.
TIA appreciate it