bgarbus851
Member
Hi,
I'm new here and a total rookie at programming. I was running a program on a version 1100 A C controller. If I try running the same program on a version
1100 B FW 16 controller a few things happen. First I get a window on rslogix500 that asks do I want to change the data tables. I have tried both changing them and not changing them. As soon as I put the unit into run mode I get a fault 0187h.Obviously there is something different but I'm not sure what.
Any help would be greatly appreciated. Thanks!!
I'm new here and a total rookie at programming. I was running a program on a version 1100 A C controller. If I try running the same program on a version
1100 B FW 16 controller a few things happen. First I get a window on rslogix500 that asks do I want to change the data tables. I have tried both changing them and not changing them. As soon as I put the unit into run mode I get a fault 0187h.Obviously there is something different but I'm not sure what.
Any help would be greatly appreciated. Thanks!!