Plug and Pray
Member
Hello everyone,
I'm trying to figure out some weird behavior with some numeric displays.
The problem is that I center numeric displays over panels but when I look at the actual HMI screen, the numeric display's numbers go outside of the panel. The development screen doesn't show this which makes it difficult to predict what anything will look like.
The only fix I've found is to decrease the font size but then it's too small.
Does anyone know why this could be happening? Thanks in advance!
I'm trying to figure out some weird behavior with some numeric displays.
The problem is that I center numeric displays over panels but when I look at the actual HMI screen, the numeric display's numbers go outside of the panel. The development screen doesn't show this which makes it difficult to predict what anything will look like.
The only fix I've found is to decrease the font size but then it's too small.
Does anyone know why this could be happening? Thanks in advance!