Micrologix 1100 problem

mylespetro said:
Not saying this is better, and I haven't actually tested it yet, but isn't it possible to go into the Advanced Config for each card and check the "Ignore Configuration Error" box in order to bench test the program with just the processor? I may be misunderstanding the issue at hand, but I have seen people mention this for testing a program (at the office for example) when you only have a processor and not the correct I/O cards. Screenshot attached. [HIGHLIGHT]Note you have to check this box for each card.[/HIGHLIGHT]
Click to expand...
Hi Thanks, THAT SEEMS TO BE WORKING!!
 
Last edited:

Similar Topics

J
MSG problem whith Micrologix 1100
Helo everyone! I am using micrologix 1100, for communicate through Ethernet IP whith 4 weighing modules, 3 of then are comunicate properly...
Replies
4
Views
774
johnd_125
J
C
Problem Connecting PV800 to Micrologix 1200/1100 w/o Ethernet
First of all Hi, nice to met you all. I have a problems trying to control my PLC's (1762-L40BWA ser. C and 1763-L16DWD ser. B) with the Panelview...
Replies
10
Views
5,054
syed_controls
S
A
Micrologix 1100, 1763L16BBB, Processor Output Problem
I'm building a model traffic light with my Micrologix 1100 processor (1763L16BBB) and two of the lamps that are controlled by relay outputs are...
Replies
6
Views
3,874
amenyo
A
A
Micrologix 1100 Communication Problem.
I'm trying to establish communication with Micrologix 1100, 1763L16BBB, processor with Windows 8.1 64 bit laptop without any success. I have read...
2
Replies
17
Views
9,613
amenyo
A
B
Micrologix 1100-Counter Problem
Rs Logix 500 Version 8.40 AB Micrologix 1100 B I have 10 counters C5:0 to C5:9. I have different bits triggering them but each counter increments...
Replies
10
Views
2,993
bernie_carlton
bernie_carlton
Back
Top Bottom