pedroascencio
Member
Hello,
Pleased !!, I need a opinion about this controlLogix configuration.
I have:
1 chassis Local and 1 chassis Remote.
In the Local chassis I have only one processor and 2 CNB modules (not redundant, just CNB).
In the Remote chasis I have 2 CNB modules and I/O digitals modules that command differents motors and read its status.
Is possible to connect each pair of CNB (Local-Remote) by separate to only one CPU?
I don't know if is possible that the CPU address the same Remote Chassis by 2 diferents networks !!!
Meaby I am going to have some problems synchronizing both networks separately by RSNetworx.
thanks in advance.!!
Pleased !!, I need a opinion about this controlLogix configuration.
I have:
1 chassis Local and 1 chassis Remote.
In the Local chassis I have only one processor and 2 CNB modules (not redundant, just CNB).
In the Remote chasis I have 2 CNB modules and I/O digitals modules that command differents motors and read its status.
Is possible to connect each pair of CNB (Local-Remote) by separate to only one CPU?
I don't know if is possible that the CPU address the same Remote Chassis by 2 diferents networks !!!
Meaby I am going to have some problems synchronizing both networks separately by RSNetworx.
thanks in advance.!!